Nylon Timing Gear – Ford Essex Engine
Since doing the gearbox on the Scimitar things were generally running well… until one day on the M25 when the throttle stuck wide open, Engine revved up to max and sounding like it was thrashing the life out of itself. I limped off the motorway by turning the ignition on and off and coasting. Free’d off the throttle at a layby and continued the 30 miles to home.
I Replaced the faulty throttle cable the following day but the car refused to start briefly spurting to life and then dying, Simple checks revealed the rotor arm was not turning but the starter was…! The timing gear had shredded its teeth leaving them all in an pile in the sump.
So I now I really have to eat a small slice of humble pie and admit I should have replaced the timing gear earlier and indeed was advised to change it by VIv at least once…! Its a well known weakness with the Ford Essex Engine and its one you Ignore at your own risk
The following photos show where the car is at present old timing gear cleaned out, new one on.
Chafed Throttle Cable
Excess amounts of blue silicone sealant courtesy of a previous owner!
Old one removed
Refitting the backplate
New steel gear
About to fit the timing cover
Going back together
bottom end view
a running engine, but not running right…
I was very lucky to get away with no serious damage, to the valves The head studs had pulled pulled out a bit but swapping for a new set of Unleaded heads has fixed this.